£25.00 – £49.50
Has your steering wheel all gone sticky and horrible, this steering wheel repair kit is the perfect solution to your problems. It’s designed for the DIY person carrying out leather repairs, BUT with professional results, this kit is perfect for steering wheel where it has colour loss and has been faded by UV rays. It’s an easy, simple to use steering wheel repair kit, all done in four easy to follow steps with the finest professional results you could imagine. Perhaps your steering wheel has been scuffed by your rings, this repair kit will resolve these issues for you.
With the leather steering wheel repair kit from the Leather Repair Company, you can restore your steering wheel to look as good as new again, but furthermore its the intelligent coating, applied that gives the new coloured steering wheel long lasting protection against the daily elements of use.
Making your old tired and worn steering wheel look like new again is a simple three stage process. Prep It Colour It Seal It A brand new looking steering wheel in no time at all. At a fraction of the cost of having to replace your steering wheel.
Now Comes with the Additional 100ml Premium Leather Cleaner..
Our Kits are unique they are a very easy, simple four stage process.
1/ First of all you will need to clean the leather thoroughly.
2/ The next step is to use the prep, this is designed to remove some of the old surface coating, the reason for doing this is its removing all old dirt, grease, waxes and oils from the surface and some of the old manufacturers finish, this then gives you a base to work from allowing the colourant to adhere correctly to the leathers surface. Without removing some of the colour, the new colour wont bond correctly.
3/ The next stage is to colour the area to be repaired.
4/ Once coloured, you then seal this over with the clear coat sealers (Gloss and Matt Finish) the gloss and matt finish can be mixed together to give you a satin finish if this is the desired look you require, this can be done by mixing them 50/50.
Spraying On Colour
Due to how the colourant dyes are made some dyes are thicker than others, the best way to thin them is using a small amount of lacquer that comes with your colour repair kit. But you can add a small amount of water if you wish, do not put in too much water as this will affect the covering power of the colourant paint.
It’s always best to apply the first coating using a sponge and then spray afterwards, do not spray from the start.
When adding water 10% should be sufficient
An airbrush type gun is best with a No5 needle spraying at around 20psi
Cleaning Out Spray Guns
Cleaning out spray guns is simple as products are water based, so you can wash the gun through with warm water or thinners if you wish.
Q. Can i use this on my gear stick
A. Yes it ideal for re colouring gear sticks.
Q. Can i use this on my door handles.
A. Yes perfect for door handles, just make sure you de-grease them fully before applying any colour
Q. Do i have to take the steering wheel off to colour it?
A. No, you can restore the wheel while still on the car, just take your time to mask everything up correctly.
Black, Bright Red, Bright Yellow, Buttermilk, Caramel, Cream, Dark Blue, Dark Brown, Dark Grey, Figaro, Green, Ivory, Lemon, Light Beige, Light Blue, Light Grey, Light Tan, Magenta, Maroon, Navy, Orange, Red Oxide, Scarlet Red, Special Colour Mix, Umber, Very Dark Graphite, Violet, White, Yellow Oxide